Of Anchor plastic 
 Feature 
 (1) two-component epoxy adhesive modified. 
 Good thixotropy, convenient and simple construction and high efficiency. 
 (3) bond strength of reinforced anchorage strength. 
 Excellent impact resistance, vibration and fatigue resistance. 
 Cured at room temperature, low temperature curing, wet environment curing, fast curing and slow curing all kinds of products. 
 Applicable 
 A new anchorage (anchor) of rebar, round bar and the old concrete structures. 
 Various types of load-bearing, non-load-bearing bolts and concrete masonry anchor. 
 Used in the construction and renovation works. 
 Typical performance indicators 
 Appearance: Group A: gray paste; Group B: yellow paste 
 Operational time (20 ° C, min): 20 ~ 60 
 Curing time (20 ° C, and h): 3 ~ 24 
 Suitable temperature (° C): -5 ℃ ~ 45 ℃ 
 Recommended proportion (by weight): A: B = 1: 0.5 
 II reinforcement anchorage in C30 concrete (7d pulling force): tensile strength of reinforcement 
 Water resistance (h / shear Mpa): 1500 /> 10 
 Hole depth (mm): 10d-20d (d: bar diameter) 
 Mixture density (g / cm 3): 1.3 to 1.7 
 Construction process 
 Drilling → the Khong → reinforced decontamination rust → rotating insert reinforced → → inject of Anchor plastic reinforced provisional fixed 
 Construction points 
 A clear hole first with a coarse nylon brush back and forth to brush the dust attached to the net hole, then high pressure air is blown to ash-free. . 
 Reinforced insert rotation, until bottom of the hole, and then gently tapping the steel more dense rubber reinforced surface contact. 
 (3) before curing, not hit to move the bars, and 24 hours before the next process. 
 4 when the temperature is low, can be mixed before the glue heating, to facilitate construction operations. 
 Packaging and storage 
 Plastic drum, A component 13kg / barrel, the B component of 7kg / barrel.